Accuracy and concurrent validity of a sensor-based analysis of sit-to-stand movements in older adults

Publikationen: Beitrag in FachzeitschriftZeitschriftenaufsätzeForschungBegutachtung

AutorInnen

Forschungseinrichtungen

Details

Body-fixed motion sensors have been applied for the assessment of sit-to-stand (STS) performance. However, the accuracy and concurrent validity of sensor-based estimations of the body's center of mass (CoM) motion during STS are unclear. Therefore, this study investigated the accuracy and concurrent validity of sensor-based measures of CoM motion during STS in older adults. Accuracy and concurrent validity were investigated by comparing the sensor-based method to a force plate method. Twenty-seven older adults (20 females, 7 males; age: 72-94 years) performed five STS movements while data were collected with force plates and motion sensors on the hip and chest. Hip maximal acceleration provided an accurate estimation of the center of mass (CoM) maximal acceleration (limits of agreement (LOA) smaller than 5% of the CoM maximal acceleration; estimated and real CoM maximal acceleration did not differ (p=0.823)). Other hip STS measures and the chest STS measures did not provide accurate estimations of CoM motion (LOA ranged from -155.6% to 333.3% of the CoM value; sensor-based measures overestimated CoM motion (range p: <0.001 to 0.01)). However, the hip sensor did not overestimate maximal jerk of the CoM (p=0.679). Moderate to very strong associations were observed between sensor-based estimations and actual CoM motion (range r=0.64-0.94, p<0.001). Hence, sensor-based estimations of CoM motion during STS are possible, but accuracy is limited. The sensor-based method cannot replace laboratory methods for a mechanical analysis of CoM motion during STS but it may be a practical alternative for the clinical assessment of STS performance in older persons.

OriginalspracheEnglisch
ZeitschriftGait & posture
Jahrgang45
Seiten (von - bis)198-203
Seitenumfang6
ISSN0966-6362
DOIs
PublikationsstatusVeröffentlicht - 03.2016

ID: 2990359

DOI

Beziehungsdiagramm anzeigen